vault backup: 2026-06-27 15:48:21

PCB Design/Music Player/Process.md

@@ -50,4 +50,6 @@ $$R = \frac{{3.3 - 3.0}}{0.16} = 1.875 \Omega$$
 For a standard value a $2.0  \Omega$ resistor will be used. This may make the display a little bit less bright but won't change it very much.Vs - Vf) / If using the maximum forward voltage:
 ### Backlight Control
 Since this device will be battery-powered and the display is not needed most of the time it needs to be able to be controlled by software by the ESP32-S3. To do this a transistor will be added to the cathode pins to control the backlight with an io pin from the microcontroller. 
-I chose [this mosfet](https://www.digikey.com/en/products/detail/infineon-technologies/IRLML2502TRPBF/811439) since it has very low resistance and should turn off and on with the 3.3V logic levels of the esp32-s3.
+I chose [this mosfet](https://www.digikey.com/en/products/detail/infineon-technologies/IRLML2502TRPBF/811439) since it has very low resistance and should turn off and on with the 3.3V logic levels of the esp32-s3.
+## USB
+There are a few considerations needed for effectively routing USB. The first is