diff --git a/PCB Design/Music Player/Process.md b/PCB Design/Music Player/Process.md
index 8bacd21..50b47b9 100644
--- a/PCB Design/Music Player/Process.md	
+++ b/PCB Design/Music Player/Process.md	
@@ -39,7 +39,7 @@ Since 3.6V are needed the values of 180K and 1.1M will be used for the feedback
 ### Layout Considerations
 Figure 31 in section 10.2 of the datasheet should be used as an example layout for the regulator
 
-It may not be entirely necessary to have this component since the battery charger should keep the output system voltage above a flor of 3.5V, but just in case I will keep it in case something
+It may not be entirely necessary to have this component since the battery charger should keep the output system voltage above a floor of 3.5V, but just in case I will keep it in case something happens and it drops below this so the LDOs can still operate fully.
 ## PCM5102A
 ## LCD Selection
 Initially I was planning to use the [NHD-2.4-240320DA-CTXN](https://www.digikey.com/en/products/detail/newhaven-display-intl/NHD-2-4-240320DA-CTXN/26743729) but I found that it requires 9.0V to drive the back light. Since I am driving this off of a single cell lipo I didn't want to add the additional complexity of another boost converter to get to 9.0V. I was able to find [another very similar display](https://www.digikey.com/en/products/detail/newhaven-display-intl/NHD-2-4-240320AF-CSXP/22204988) that instead uses 3.0V (up to 3.3V) to power the back light.